iPIO-8 compatibility

iPIO-8 compatibility

Postby DP_Sam » October 11th, 2012, 4:12 pm

When connecting newer iPIO-8 firmware devices, like 1.21.105 to older utilities, cuscom code you wrote, or even older iPIO-8 units, it may be necessary to disable the DxP password and username use.
A checkbox can be found on the network setup page labeled "Use DxP Username and Password"
Older units did not support the password, so the box should be unchecked.
Sam Savoye
Dataprobe Tech Support
SSavoye@Dataprobe.com
DP_Sam
 
Posts: 123
Joined: January 21st, 2010, 9:39 am
Location: Allendale, NJ

Return to Remote Control (iPIO-8)

Who is online

Users browsing this forum: No registered users and 1 guest

cron