admin user not working
Posted: March 14th, 2017, 5:20 pm
I have two iBootBar units installed at a factory.
Both units respond to ping, they accept a telnet connection and they both serve a WebUI.
I cannot log into the devices as admin/admin
They were up and working fine for over a year, but suddenly we can't run our automated test that connects with telnet.
We can't use the SCU utility to control the iBootBar either.
I had the remote operator press the reset button on the front for 5 seconds, and we could log in as admin/admin via telnet but we couldn't do anything from the CLI.
I tried creating a new user, the user was created and I can log in via telnet, but can't do anything.
I'm guessing that the user database is corrupted.
What can I do to recover these units?
Running iBootBar Rev 1.5d.275
Both units respond to ping, they accept a telnet connection and they both serve a WebUI.
I cannot log into the devices as admin/admin
They were up and working fine for over a year, but suddenly we can't run our automated test that connects with telnet.
We can't use the SCU utility to control the iBootBar either.
I had the remote operator press the reset button on the front for 5 seconds, and we could log in as admin/admin via telnet but we couldn't do anything from the CLI.
I tried creating a new user, the user was created and I can log in via telnet, but can't do anything.
I'm guessing that the user database is corrupted.
What can I do to recover these units?
Running iBootBar Rev 1.5d.275