Autoping feature requests - interface status and new mode

Moderator: DP_Sam

Autoping feature requests - interface status and new mode

Postby alanh » August 29th, 2012, 8:52 am

Hi,
I would like the iBoot to have the option to check if its network interface is up before doing an autoping action if it cannot ping an IP.

I would also like a new mode where it will perform an autoping action only if it cannot ping "AutoPing 1" and can ping "AutoPing 2".

Thanks.
alanh
 
Posts: 1
Joined: August 29th, 2012, 7:03 am

Re: Autoping feature requests - interface status and new mod

Postby DP_Sam » August 30th, 2012, 4:53 pm

Alan,

That is a good idea. If the cable is disconnected, why cycle power?
I think it may have to be a selectable option though.

I will pass along the good idea.

Thanks again,
Sam Savoye
Dataprobe Tech Support
SSavoye@Dataprobe.com
DP_Sam
 
Posts: 123
Joined: January 21st, 2010, 9:39 am
Location: Allendale, NJ


Return to iBoot

Who is online

Users browsing this forum: No registered users and 1 guest

cron